加拿大Solinst无线电RRL遥测系统（9200）

加拿大Solinst无线电RRL遥测系统（9200）

产品名称：无线电RRL遥测系统
品牌：Solinst
产地：加拿大
型号：9200


远程无线电链路 (RRL) - 9200 型系统提供了一种非常简单且成本低廉的本地遥测方法。数据通过短距离无线电从现场发送到您的 Home Station PC。RRL 非常适合小型闭环网络，例如矿场、高尔夫球场和垃圾填埋场监控网络。通过使用免费的未许可无线电频段 (ISM)，RRL 具有比蜂窝遥测系统成本更低的优势。


RRL 站：
RRL 站与全向天线、视距传输一起工作，因此，它们可以在长达 20 英里（30 公里）的距离上进行通信。可选天线和使用一些电台作为中继器可以**限度地扩大距离。
RRL 站使用 900 MHz 无线电模块。他们使用六节可更换的锂电池，还可以选择备用电源。**多可以将四个 Solinst 数据记录器连接到一个 RRL（使用两个分路器）。每个 RRL 上的 RS232 连接用于诊断、固件更新和编程目的。
所有 RRL 站都使用相同的硬件，并使用 Solinst 遥测软件中的向导进行编程，作为主站、远程站或中继站（中继器）。
RRL 站可根据需要互换。RRL 站有一个非易失性内部存储器，它们存储收集到的数据，直到成功联系到主站。

远程无线电链路 (RRL) - 9200 型操作：

系统按两个基本时间表运行。设置采样率，RRL 记录每个连接的数据记录器的实时读数。报告速率是数据从 RRL 发送到 Home Station PC 的频率。可选地，数据记录器可以设置为独立于 RRL 记录和存储数据。
报告的数据保存在 Home Station PC 上动态更新的数据库中，也可以使用 Solinst 遥测软件查看和导出。您可以完全控制您的数据。

 

远程无线电链路 (RRL) - 9200 型参数：

沟通：900 MHz 无线电
天线：6" (15 cm) 半波，(2.1dBi) 非铰接式
数据文件类型：.mdb（数据库）、.xle 或 .csv（导出）
采样间隔：10 秒 - 99 小时
报告间隔：1 分钟 - 99 小时
计划编程：家庭站的 Solinst 遥测软件
电源：6节3.6V AA可更换锂电池
电池寿命示例：680 天，基于每小时采样和每天两次报告（1 瓦设置）
内存容量：（
报告之间）128 KB（13,000 LT 或 10,000 LTC 读数）
工作温度：-20ºC 至 50ºC
尺寸：适合 4.5" 直径的井
IP等级：IP66（防尘防水，不可浸没）
兼容的数据记录器：Levelogger Edge、Barologger Edge、 Levelogger Junior Edge、LTC Levelogger Edge 、Rainlogger Edge、LevelVent和AquaVent，以及 Levelogger Gold、Barologger Gold、Levelogger Junior、LTC Levelogger Junior 和 Rainlogger
连接的数据记录器数量：4
气压补偿：在 Solinst 遥测软件中自动执行或由用户在外部数据库中执行



中文内容来自机器翻译，内容仅供参考，实际内容可参考原厂介绍或以合同为准。
英文原文：

Remote Radio Link (RRL) - Model 9200:
The Solinst RRL System offers a very simple and inexpensive method of local telemetry. Data is sent from the field via shortdistance radio to your Home Station PC. The RRL is excellent for small, closed loop networks such as mine sites, golf courses, and landfill monitoring networks. By using free unlicensed radio bands (ISM), the RRL has the advantage of being lower cost than cellular telemetry systems.

RRL Networks do have the option of bridging with a Solinst STS Edge Telemetry System (see Model 9100 Data Sheet).




RRL Stations:
RRL Stations work with omnidirectional antenna, line-ofsight transmission, therefore, they can communicate over distances up to 20 miles (30 km). Optional antennas and using some stations as repeaters can maximize distances.

RRL Stations use a 900 MHz radio module. They use six replaceable lithium batteries, and also have the option of a back-up power source. Up to four Solinst dataloggers can be connected to one RRL (using two Splitters). The RS232 connection on each RRL is used for diagnostic, firmware updates and programming purposes.

All RRL Stations use the same hardware, and are programmed using a wizard in Solinst Telemetry Software as a Home Station, Remote Station or Relay Station (repeater).

RRL Stations are interchangeable as required. RRL Stations have a non-volatile internal memory, and they store collected data until the Home Station has been successfully contacted.


RRL Telemetry Operation:
Systems operate on two basic schedules. A sample rate is set, at which an RRL records a real-time reading from each attached datalogger. A report rate is the frequency that the data is sent from an RRL to the Home Station PC. Optionally, dataloggers can be set up to record and store data independently of the RRL.

Reported data is saved in a dynamically updated database on the Home Station PC, and can also be viewed and exported using Solinst Telemetry Software. You have complete control of your data.

 

Remote Radio Link Specifications:
Communication:    900 MHz radio
Antenna:    6" (15 cm) half wave, (2.1dBi) non-articulating
Data File Type:    .mdb (database), .xle or .csv (exported)
Sampling Interval:    10 seconds - 99 hours
Reporting Interval:    1 minute - 99 hours
Schedule Programming:    Solinst Telemetry Software at Home Station
Power Supply:    6 3.6V AA replaceable lithium batteries
Battery Life Example:    680 days based on hourly sampling and reporting twice a day (1 Watt setting)
Memory Capacity:
(Between Reports)    128 KB (13,000 LT or 10,000 LTC readings)
Operating Temperature:    -20ºC to 50ºC
Size:    Fits in a 4.5" diameter well
IP Rating:    IP66 (dust and water proof, can not be submerged)
Compatible Dataloggers:    Levelogger Edge, Barologger Edge, Levelogger Junior Edge, LTC Levelogger Edge, Rainlogger Edge, LevelVent, and AquaVent, as well as Levelogger Gold, Barologger Gold, Levelogger Junior, LTC Levelogger Junior and Rainlogger
Number of Connected dataloggers:    4
Barometric Compensation:    Automatically performed in Solinst Telemetry Software or by user in external database

---

提示：“加拿大Solinst品牌9200产品”内容及图片来自厂商官网、翻译或互联网引用等，内容仅供参考，以最终签订合同为准，如有差错或异议可联系我们更改。