加拿大Solinst驱动采样压力计（615N）

加拿大Solinst驱动采样压力计（615N）

产品名称：驱动采样压力计
品牌：Solinst
产地：加拿大
型号：615N

Solinst 615N 型驱动点渗压计设计为没有用于水位测量的管道倒钩。这可以节省资金并为水位计提供更好的访问权限。
615 型驱动点渗压计是一种经济实惠的方法，可在合适的条件下监测浅层地下水和土壤蒸汽。
驱动点连接到便宜的 3/4" (20 mm) NPT 不锈钢驱动管。驱动点设计用于一次性安装，不用于拆卸和重复使用。索林斯特驱动点渗压计通常作为永久性安装井点。它们也可以用于临时的、短期的监测应用。
当聚乙烯或聚四氟乙烯内衬管连接到不锈钢驱动点时，可以获得更高质量的样品。可以使用小直径设备在管道内进行地下水采样和水头测量。
Solinst 驱动点渗压计可以通过任何直接推动或钻孔技术（包括手动滑锤）进入地下。为避免在安装过程中堵塞或弄脏屏幕，还提供屏蔽版本。615 个 ML 端口为一个驱动器中多达 6 个区域的多级监控提供了选项。

 

加拿大Solinst驱动采样压力计（615N）应用：

高分辨率垂直轮廓
地下水采样，包括 VOC
多级地下水监测
水位监测
河床基流监测
污染物羽流轮廓
土壤气体采样
UST监控
低成本和**小干扰现场评估
喷雾点
垂直地层剖面


615N 简易井点
水位监测和地下水采样

615 N 设计为不带管倒钩，用于水位测量。这可以节省资金并为水位计提供更好的访问权限。

Solinst 驱动点渗压计有五种不同的配置。带倒钩接头的 615、不带倒钩接头的 615 N、带压缩接头的 615 C、带倒钩接头和护罩的 615 S、带护罩和不带倒钩接头的 615 SN，以及带护罩的 615 ML双倒钩端口阀杆。

中文内容来自机器翻译，内容仅供参考，实际内容可参考原厂介绍或以合同为准。
英文原文：

The Model 615 Drive-Point Piezometer is designed as an affordable method to monitor shallow groundwater and soil vapor in suitable conditions.

The Drive-Points attach to inexpensive 3/4" (20 mm) NPT stainless steel drive pipe. The Drive-Points are designed for single use installations, and not for removal and reuse. Solinst Drive-Point Piezometers are most often installed as permanent well points. They can also be used for temporary, short term monitoring applications.

Higher quality samples can be obtained when polyethylene or PTFE-lined tubing is attached to the stainless steel drive-point. Groundwater sampling and hydraulic head measurements can be taken within the tubing using small diameter equipment.

Solinst Drive-Point Piezometers can be driven into the ground with any direct push or drilling technology, including the Manual Slide Hammer. To avoid clogging or smearing of the screen during installation, a shielded version is also available. 615 ML ports provide the option for multilevel monitoring for up to 6 zones in one drive.

 

Applications：
High-resolution vertical profiling
Groundwater sampling, including VOCs
Multilevel groundwater monitoring
Water level monitoring
Base flow monitoring in stream beds
Contaminant plume delineations
Soil gas sampling
UST monitoring
Low cost and minimal disturbance site assessment
Sparge points
Vertical stratigraphy profiling




High Quality Samples：

Model 615 Drive-Point Piezometers have a stainless steel, 50 mesh cylindrical filter-screen (100 mesh for ML), within a 3/4" (20 mm) stainless steel drive-point body, screen support and an optional fitting for attachment of sample tubing.

The 615 N or 615 SN, designed without a tubing barb, is to be used for water level measurements. This saves money and provides better access for Water Level Meters.

The 615 or 615 S has an inner barbed fitting for 5/8" OD x 1/2" ID (16 mm x 12 mm) LDPE or PTFE-lined sample tubing. This prevents sample water from contacting the extension rods, and maintains high sample integrity, even when inexpensive galvanized steel extensions are used.

The 615 C is ideal for soil vapor sampling. Where an air-tight connection is most desirable, the compression fitting option allows users to attach 1/4" OD (6 mm) sample tubing directly to the top of the screened portion of the drive-point.

The 615 S and 615 SN shielded drive points have a single use, 1-1/2" (38 mm) dia. shield to avoid smearing and plugging of the screen during installation. The strengthened connector at the top of the drive-point acts as an annular seal, which avoids contamination from higher levels in the hole.

The 615 ML Multilevel Drive-Point Ports have a dual barb stem to allow the connection of 3/8" OD (9.5 mm) or 1/4" OD (6 mm) tubing. The 615 ML uses the same couplings and extensions as the standard 615 Piezometers, but with a Drive-Point Tip to thread onto the first extension, or Port. Formation water enters the port, passes into the stem, and up into the monitoring tube attached to the stem to its static level. The 615 ML is also a good option for high resolution profiling of soil gas, or groundwater.

 
Solinst Drive-Point Piezometers are available in five different configurations; the 615 with a barbed fitting, the 615 N with no barbed fitting, the 615 C with a compression fitting, the 615 S with a barbed fitting and shield, the 615 SN with a shield and no barbed fitting, and the 615 ML with a dual barb port stem.

---

提示：“加拿大Solinst品牌615N产品”内容及图片来自厂商官网、翻译或互联网引用等，内容仅供参考，以最终签订合同为准，如有差错或异议可联系我们更改。